BoPin 630 Premium Paintable Acrylic Sealant_benefit

Keo dán Acrylic cao cấp BoPin 630

BoPin 630 is a single-component, water-based acrylic sealant produced using imported emulsion for superior performance consistency and finish quality. It cures by water evaporation at room temperature, forming a flexible, paintable seal that protects joint edges and blends seamlessly with surrounding decorated surfaces. The low-stress formula prevents damage to adjacent paint coatings, wallpaper and delicate substrate finishes during and after application. Suitable for interior dry-area joint finishing, wall crack repair and decorative trim sealing where a high-quality, professional result is required.

Lợi ích chính

Produced with imported emulsion — consistent quality and superior finish versus standard acrylic formulations
Fully paintable after cure — compatible with water-based and most synthetic paints
Low-stress formula — protects adjacent paint coatings, wallpaper and delicate surface finishes
Good adhesion to concrete, plastic and timber without primer
Water clean-up of uncured product — easy application and tooling
Low odour water-based formula — safe for use in occupied interior spaces
Low VOC content — suitable for green building interior requirements

Adhere To

Concrete and plaster
Wood and timber boards
Plastic and PVC profiles
Drywall and gypsum board
Most interior dry-area surfaces

Application Areas

Cabinet, wall panel and wallpaper edge finishing and cosmetic sealing in dry areas
Interior door and window frame perimeter joint sealing
Skirting board and PU moulding edge sealing
Interior wall and ceiling crack repair

Bưu kiện

300ml cartridge — 24 units per carton
Available colors upon request

Thông tin bổ sung

Hệ thống bảo dưỡng	Sự bốc hơi nước
Density (g/cm³)	1.43 ± 0.03
Độ cứng (Shore A)	30–50
Độ bền kéo	≥0.8 MPa
Độ giãn dài khi đứt	≥100%
Thời gian hình thành da	20–30 min
Nhiệt độ ứng dụng	+5°C đến +40°C
Hạn sử dụng	12 months (unopened, frost-free, ≤25°C)
Màu sắc	Đen, Tùy chỉnh, Xám, Trắng
Standard	JC/T 484-2006

Chuẩn bị bề mặt — Ensure surfaces are clean, dry and free from dust, grease and loose material. Substrate moisture content must not exceed 12%.
Ứng dụng — Cut cartridge tip at 45°, load into sealant gun and apply with steady, even pressure. Smooth with a wet spatula or damp finger within the working time.
Curing — Allow to cure at room temperature with adequate ventilation. Paint only after the surface is fully dry and no longer tacky.
Cleanup — Remove uncured product with water and a damp cloth. Cured product must be removed mechanically.

Limitations

Strictly not suitable for areas subject to prolonged water contact or immersion
Not suitable for structural joints
Not recommended when substrate temperature is below 5°C or above 40°C
Not recommended when ambient humidity exceeds 80% or substrate moisture content exceeds 12%
Không phù hợp với các mối nối ngoài trời tiếp xúc trực tiếp với thời tiết

Mẹo

For best paintability, allow full cure before applying paint — painting too early may cause surface cracking
Slightly moisten very porous substrates such as plaster or brick before application to improve adhesion
Product must be protected from freezing during storage and transport
Store cartridges upright in a cool, dry location away from heat sources