BoPin 630 Premium Paintable Acrylic Sealant_benefit

BoPin 630 Selante Acrílico Pintável Premium

BoPin 630 is a single-component, water-based acrylic sealant produced using imported emulsion for superior performance consistency and finish quality. It cures by water evaporation at room temperature, forming a flexible, paintable seal that protects joint edges and blends seamlessly with surrounding decorated surfaces. The low-stress formula prevents damage to adjacent paint coatings, wallpaper and delicate substrate finishes during and after application. Suitable for interior dry-area joint finishing, wall crack repair and decorative trim sealing where a high-quality, professional result is required.

Principais benefícios

Produced with imported emulsion — consistent quality and superior finish versus standard acrylic formulations
Fully paintable after cure — compatible with water-based and most synthetic paints
Low-stress formula — protects adjacent paint coatings, wallpaper and delicate surface finishes
Good adhesion to concrete, plastic and timber without primer
Water clean-up of uncured product — easy application and tooling
Low odour water-based formula — safe for use in occupied interior spaces
Low VOC content — suitable for green building interior requirements

Aderir a

Concreto e gesso
Wood and timber boards
Plastic and PVC profiles
Drywall and gypsum board
Most interior dry-area surfaces

Áreas de aplicação

Cabinet, wall panel and wallpaper edge finishing and cosmetic sealing in dry areas
Interior door and window frame perimeter joint sealing
Skirting board and PU moulding edge sealing
Interior wall and ceiling crack repair

Embalagem

300ml cartridge — 24 units per carton
Available colors upon request

Informação adicional

Sistema de cura	Evaporação da água
Density (g/cm³)	1.43 ± 0.03
Dureza (Shore A)	30–50
Resistência à tração	≥0.8 MPa
Alongamento na rutura	≥100%
Tempo de formação da pele	20–30 min
Temperatura de aplicação	+5°C a +40°C
Prazo de validade	12 months (unopened, frost-free, ≤25°C)
Cor	Preto, Personalizado, Cinzento, Branco
Padrão	JC/T 484-2006

Preparação da superfície — Ensure surfaces are clean, dry and free from dust, grease and loose material. Substrate moisture content must not exceed 12%.
Aplicação — Cut cartridge tip at 45°, load into sealant gun and apply with steady, even pressure. Smooth with a wet spatula or damp finger within the working time.
Cura — Allow to cure at room temperature with adequate ventilation. Paint only after the surface is fully dry and no longer tacky.
Limpar — Remove uncured product with water and a damp cloth. Cured product must be removed mechanically.

Limitações

Strictly not suitable for areas subject to prolonged water contact or immersion
Not suitable for structural joints
Not recommended when substrate temperature is below 5°C or above 40°C
Not recommended when ambient humidity exceeds 80% or substrate moisture content exceeds 12%
Não é adequado para juntas exteriores com exposição direta às intempéries

Dicas

For best paintability, allow full cure before applying paint — painting too early may cause surface cracking
Slightly moisten very porous substrates such as plaster or brick before application to improve adhesion
Product must be protected from freezing during storage and transport
Store cartridges upright in a cool, dry location away from heat sources