BoPin 110 All-Purpose Acetoxy Silicone_Applications

BoPin 110 All-Purpose Acetoxy Silicone_Benefits

BoPin 110 Sellante de silicona acetoxi multiuso

BoPin 110 is a single-component, acetoxy-cure silicone sealant designed for general glazing and sealing applications. It cures rapidly at room temperature upon exposure to moisture, forming a durable, flexible rubber that maintains performance across a wide temperature range. Fast skin formation and strong adhesion to glass and ceramic surfaces make it a reliable choice for window installation, decorative glass bonding, and professional gap filling.

Principales ventajas

Fast cure — tack-free within 8 minutes, significantly faster than neutral-cure alternatives
Strong adhesion to glass, glazed ceramics, and anodised aluminium without primer
Excellent elongation (≥400%) providing good flexibility under movement
UV resistant — resists ageing, yellowing and degradation from solar exposure
Rendimiento estable desde -50 °C hasta +170 °C.
Non-sag formula suitable for vertical and overhead joints

Adherirse a

Superficies acristaladas
Anodised aluminium
Glazed ceramic tiles
Non-oily timber

Áreas de aplicación

Window and door frame installation and sealing
Decorative glass panel bonding and sealing
General-purpose gap filling by professional applicators
Aluminium window and door frames to wall joint sealing
Glass display cabinets and shopfront glazing

Paquete

Cartucho de 300 ml — 24 unidades por caja
Colores disponibles bajo petición.

Información adicional

Material de base	Silicona acetoxi
Sistema de curado	Acetoxy (acid cure)
Sag / Slump	≤3 mm
Tiempo de formación de la piel	≤8 min
Working Time	≤10 min
Tasa de curado (profundidad)	1–2 mm/day
Dureza (Shore A)	20
Resistencia a la tracción	≥1.0 MPa
Alargamiento a la rotura	≥400%
Capacidad de movimiento	±15%
Resistencia a la temperatura	-50°C a +170°C
Color	Negro, Marrón, Transparente, Personalizado, Gris, Blanco
Vida útil	12 meses (sin abrir, ≤25°C)
Estándar	JC/T 485-2007

Preparación de la superficie — Ensure all surfaces are clean, dry and free from dust, grease and old sealant residues.
Aplicación — Cut cartridge tip at 45°, load into sealant gun and apply with steady, even pressure. Tool within the working time using a wet spatula.
Curación — Allow to cure at room temperature. Avoid water contact for at least 24 hours. Full mechanical properties are reached after 7 days.
Limpieza — Remove uncured sealant with a solvent. Cured sealant must be cut away mechanically.

Limitaciones

No apto para aplicaciones de carga estructural.
Not recommended for movement exceeding ±15%
No recomendado para inmersión continua en agua
Do not use in fully enclosed spaces without ventilation — releases acetic acid (vinegar odour) during cure
Do not apply directly to mirror reflective coatings — acid may damage the backing
Do not use on natural stone (marble, limestone, travertine) — acid may cause staining
Do not use on copper, brass, zinc or other acid-sensitive metals — corrosion may occur
Do not use on surfaces containing plasticiser or solvent residues
No aplicar cuando la temperatura del sustrato sea inferior a 4 °C o superior a 40 °C.

Consejos

For best tooling results, use a small amount of soapy water on the spatula to achieve a smooth finish
Always conduct a compatibility test on actual project materials before full application
Store upright in a cool, dry place away from direct sunlight