Sellador de silicona ecológico multiusos BoPin 120

BoPin 120 Multi-Purpose Eco Silicone Sealant_Applications

BoPin 120 Multi-Purpose Eco Silicone Sealant_Benefits

Sellador de silicona ecológico multiusos BoPin 120

BoPin 120 is a single-component, silane-modified sealant that combines the flexibility of silicone with excellent adhesion to a wide range of substrates. It cures at room temperature by reacting with moisture in the air, producing an odourless, flexible rubber with very low VOC content. The solvent-free, paintable formula makes it suitable for both professional contractors and general construction applications where substrate compatibility and environmental performance are priorities.

Principales ventajas

Paintable after cure — compatible with most water-based and solvent-based paints
Very low VOC — odourless after cure, suitable for occupied spaces
Excellent adhesion to a wide variety of substrates without primer
Solvent-free formula — does not shrink or crack during cure
Anti-bacterial and anti-mould properties
Good deformation capability accommodating minor structural movement
Stable performance across high and low temperature extremes

Adherirse a

Superficies acristaladas
Aluminium, steel and powder-coated metals
Azulejos de cerámica y porcelana
Concrete, brick and masonry
Non-oily timber
Most plastics (compatibility test recommended before use)

Áreas de aplicación

Window and door frame installation and perimeter sealing
General-purpose gap filling and joint sealing by professional applicators
Tile, brick, stone and concrete joint filling and sealing

Paquete

Cartucho de 300 ml — 24 unidades por caja
600ml sausage pack — 20 units per carton
Colores disponibles bajo petición.

Información adicional

Sistema de curado	Silane-modified (moisture cure)
Solvent Content	None
Contenido de COV	Very low
Resistencia a la temperatura	Resistant to high and low temperature extremes
Vida útil	12 months (unopened, stored ≤25°C)
Color	Negro, Marrón, Transparente, Personalizado, Gris, Blanco

Preparación de la superficie — Ensure surfaces are clean, dry and free from dust, grease and old sealant residues.
Aplicación — Cut cartridge tip at 45°, load into sealant gun and apply with steady, even pressure. Tool the joint within the working time using a wet spatula.
Curación — Dejar curar a temperatura ambiente con ventilación adecuada. Las propiedades mecánicas completas se desarrollan después de 7 días.
Limpieza — Remove uncured product with a suitable solvent. Cured product must be removed mechanically.

Limitaciones

Not recommended for joints subject to significant movement
No recomendado para inmersión continua en agua
Not recommended for use in fully enclosed, unventilated spaces
Not recommended for surfaces containing plasticiser or solvent residues
No aplicar cuando la temperatura del sustrato sea inferior a 4 °C o superior a 40 °C.
Not suitable for areas subject to prolonged water contact

Consejos

Paintability is one of the key advantages of this product — allow full cure before painting for best adhesion
Realice una prueba de compatibilidad y adhesión en sustratos reales del proyecto antes de su aplicación completa.
Store in a cool, dry place away from direct sunlight